Brother HL-1020, HL-820, HL-1040 manual Installing the Simm

Installing the SIMM

To install the SIMM, follow these steps:

1

2

Turn off the power switch and unplug the p cord from the AC outlet. Disconnect the inte cable (printer cable) from the printer.

!Caution

Be sure to turn off the power switch and unplug the power cord to the printer before installing or removing the SIMM to/from the main controller board.

Unscrew the screws securing the rear plate of the main controller board to the printer and pull out the main controller board .

Unpack the SIMM and hold it by its edge.

!Caution

SIMM boards may be damaged by even a small amount of static electricity. Do not touch the memory chips or the board surface. When handling the board and before installing or removing it, wear an antistatic wrist strap, or frequently touch the surface of the antistatic package or bare metal on the printer.

3

Install the SIMM into the slot and push it gently towards the vertical until it clicks into place.

4.Install the main controller board into the printer by sliding it into the guide rails.

5.Secure the main controller board with the four screws.

6.Reconnect the interface cable (printer cable) from your computer. Plug the power cord into the AC outlet and turn on the power switch.

7.To check that the SIMM is installed correctly, you may perform a Test Print “Print Configuration” which will print the current total memory size.

34