Brother HL-1040, HL-820, HL-1020 manual III-7

PR98292

(5)Release the right side of the paper eject roller shaft.

(6)Remove the four eject pinch rollers and the pinch springs from the fixing unit frame. Then, remove the pinch spring from each pinch roller.

Paper eject roller shaft

Pinch Spring

Eject Pinch Roller

Fig. 3-8a

(7)Remove the M3x10 self tapping screw securing the connector plate.

(8)Remove the connector plate from the fixing unit frame and loosen the other M3x10 tapping screw securing the fixing unit cover.

(9)Remove the idle gear 16 from the fixing unit frame to remove the heat roller. Then, remove the halogen heater lamp from the heat roller.

Caution :

Never touch the surface of the halogen heater lamp and the heat roller.

	Halogen heater lamp	Heat Roller Bearing
	(Blue 100V, Red 200V)
Groove	Heat roller
Heat Roller Bearing		Taptite, pan

Heat Roller Washer

Retaining ring

Heat roller gear

M3x10

Idle gear 16

Taptite, pan M3x10

Fixing unit frame

Connector plate

Fig. 3-9

Note:

When re-assembling the bearing at the both ends of the heat roller, ensure that the

￿direction of the bearing is correct referring to the above figure.

The heat roller itself is very similar to the one for HL-1060/1070 printers. The heat roller for the HL-820/1020/1040/1050 printers can be distinguished by the groove on the edge of the roller. (Refer to the above figure.)

III-7