Brother MFC4450 manual Remote Control Commands, Pagingsetting

MFC 4450/OP-US-5.0

REMOTE FAX OPTIONS

Remote Control Commands

You can control your MFC with the following remote control commands.

Remote control command			DetailOperation
95	Changing Fax Forwarding
	/Pagingsetting
	1	O F F	If you hear one long beep, the change is accepted. If you hear
			three short beeps, you can not change it because the conditions
	2	Fax Forwarding
			(ex. registering fax forwarding or paging number) have not been
			completed. You can register your fax forwarding number by
	3	Paging
			using 4. FAX FWD No. (see page 8-10). Once you have registered
			the number, the MFC automatically will turn to “FAX FWD:ON”
	4	FAX FWD No.
			mode. To receive a Memory Status List, enter 961 (see page 8-
			10). Check the List to make sure the Fax Forwarding number
	5	FWD No. Confirm
			you registered is correct. Then enter the confirmation command
			955. Now the MFC will start Fax Forwarding.
	6	Fax Storage ON	You can set FAX STORAGE ON or OFF.
	7	Fax Storage OFF
96	Retrieve FAX
	1	Memory Status List	You must call from a remote fax machine to receive the Memory
			Status List or stored fax message(s). (See page 8-10.)
	2	00 Retrieve all FAXES
	2 “MSG No.” 00
		Retrieve by MSG
		number
	3	Erase FAX in the	If you hear one long beep, you can erase fax message(s) from the
		memory	memory.
97 Check the receiving status			You can check whether your MFC has received any fax message(s).
			Ifyes,youwillhearonelongbeep.Ifno,youwillhearthreeshort
	1	FAX
			beeps.
98	Change Answer Mode		If you hear one long beep, you can change the Answer Mode. If
			you hear three short beeps, you can not change it.
	1	T A D
	2	F/T
	3	Fax
90	Exit		After a long beep, you can exit remote control.

8 - 9