Manual and automatic fax redial

If you’re sending a fax manually and the line is busy, press Redial/Pause and then press Fax Start to try again. If you want to make a second call to the last number you dialed, press Redial/Pause and then press Fax Start to save time.

Redial/Pause only works when you dial using the control panel. If you’re sending a fax automatically and the line is busy, the MFC will automatically redial one time five minutes after the transmission.

Dual Access (Not available for color faxes)

You can place an original in the ADF and set temporary settings, dial a number, and begin scanning the fax into memory-even when the MFC is receiving, sending or printing a fax from memory. The LCD shows the new job number and available memory.

1

2

3

If you get a OUT OF MEMORY message while scanning the first page of a fax, press Stop/Exit to cancel scanning. If you get a OUT OF MEMORY message while scanning a subsequent page, you can press Fax Start to send the pages scanned so far, or press Stop/Exit to cancel the operation.

Place the original face up in the ADF, or face down on the scanner glass.

Enter the fax number.

Press Fax Start.

The MFC scans the original and the LCD shows the job number (#XXX) of the fax and how much memory is available. Then the MFC starts dialing. You can repeat Steps 1 to 3 for the next fax.

Your machine normally uses Dual Access. However, to send a color fax, you must use Real Time Transmission.

The Number of pages you can scan into the memory will vary depending on the data that is printed on them.

SETUP SEND 6 - 8