Brother XE5427-001, 885-V51 operation manual Start/stop button lights up in orange

GETTING READY ————————————————————————————————————————————

aTurn on the machine.

bPlace the bobbin on the bobbin winder shaft so that the spring on the shaft fits into the notch in the bobbin.

Press down on the bobbin until it snaps into place.

a

b

aNotch

bBobbin winder shaft spring

cSlide the bobbin winder in the direction of the arrow until it snaps into place.

X (Start/stop button) lights up in orange.

dPick up the spool pin and remove the spool cap that is inserted onto the spool pin.

a b

aSpool cap

bSpool pin

ePlace the spool of thread for the bobbin onto the spool pin.

Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom.

Memo

zUse the embroidery bobbin thread for embroidering.

Note

zIf the spool is not positioned so that the thread unwinds correctly, the thread may become tangled around the spool pin.

fSlide the spool cap onto the spool pin and return the spool pin to its original position. Slide the spool cap as far as possible to the right as shown, with the rounded side on the left.

CAUTION

●If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the machine may be damaged.

●Three spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the machine may be damaged.

30