Brother 885-V51, XE5427-001 Make sure that the thread passes under the pretension disk

————————————————————————————————————————————————————

Note

hPass the thread behind the thread guide cover and to the front.

zWhen embroidering with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool.

c b

a

aSpool cap (small)

bSpool (cross-wound thread)

cSpace

While holding the thread near the spool with your right hand, pull the thread with your left hand as shown below.

a

1

zWhen using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin. If the spool net is too long, fold it to fit the size of the spool.

When the spool net is used, the upper thread tension may become tighter. Before embroidering, refer to "Adjusting the upper thread tension" (page 63).

a b

c

d

aSpool net

bSpool

cSpool cap

dSpool pin

gPull the thread from the spool and pass the thread under the hook of thread guide.

a Thread guide cover

iPull the thread to the right, pass it under the hook of the bobbin-winding thread guide, and then wind the thread counterclockwise under the pretension disc, pulling it in as far as possible.

a

aBobbin-winding thread guide

Make sure that the thread passes under the pretension disk.

b

cd

bHook

cPretension disk

dPull it in as far as possible.

a

aThread guide

Winding/Installing the Bobbin 31