Brother 885-V51, XE5427-001 Attaching the Embroidery Frame, Attaching the embroidery frame

————————————————————————————————————————————————————

Attaching the Embroidery Frame

This section describes how to attach the embroidery frame.

Attaching the embroidery frame	Firmly insert the embroidery frame guide into	1
	ethe embroidery carriage frame holder from the
	top.
Wind the embroidery bobbin thread onto the	Line up the embroidery frame guide tabs and
abobbin and set it into the bobbin case.	the embroidery carriage frame holder slots and
• For details, refer to "Winding/Installing the	push in until it clicks and stops.
Bobbin" (page 29).	a

bRaise the presser foot lever.

a

aPresser foot lever

Press	(Needle position button) once or	b
ctwice to raise the needle.		a Embroidery frame guide tabs
	a	b Embroidery carriage frame holder slots

X The embroidery unit is attached.

Note

z Be sure to insert both pins. If only the forward or the back pin is inserted, the pattern may not turn out correctly.

aNeedle position button

Pass the embroidery frame under the presser	CAUTION
dfoot while raising the presser foot lever even	● Correctly set the embroidery frame into
further.
	the embroidery frame holder. Otherwise,
	the embroidery foot may hit the
	embroidery frame, resulting in injury.

CAUTION

●Do not touch the start/stop button or needle position button. If one of the buttons is accidentally pressed, the machine will move and your finger may be pricked with the needle or the needle may break.

Attaching the Embroidery Frame 47