APPENDIX ——————————————————————————————————————————————

Attaching the Embroidery Foot

This section describes how to attach the embroidery foot "Q".

Attaching the embroidery foot

If you need to replace the embroidery foot, attach the embroidery foot "Q" as follows.

a

b

aEmbroidery foot bar

bCaught by the presser foot holder screw

CAUTION

Always use the embroidery foot "Q" when embroidering. If the wrong embroidery foot is used, the needle may hit the embroidery foot and bend or break.

aPress (Needle position button) once or twice to raise the needle.

a

aNeedle position button

Note

zThe needle is correctly raised when the mark on the handwheel is at the top. Check the handwheel mark is at the top position.

bTurn off the machine.

CAUTION

zBefore attaching the embroidery foot, be sure to turn off the machine. Otherwise, injuries may occur if one of the operation buttons is accidentally pressed and the machine starts embroidering.

cRaise the presser foot lever.

a

aPresser foot lever

dHold the embroidery foot "Q" with your right hand, as shown.

Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot.

a

aLever

76

Page 78
Image 78
Brother XE5427-001, 885-V51 operation manual Attaching the Embroidery Foot, Attaching the embroidery foot