Brother 885-V51, XE5427-001 operation manual Adjusting the LCD, Operation beep

————————————————————————————————————————————————————

Adjusting the LCD

If nothing appears in the LCD when the machine is turned on, the brightness of the LCD is either too light or too dark. In such a case, perform the following operation.

aTurn off the machine.

bTurn on the machine while pressing any of the

operation panel keys except (Help key).

cPress or .

dTurn off the machine, then turn it on again.

Operation beep

Each time a key is pressed you will hear one beep. If an incorrect operation is performed you will hear two or four beeps.

■If a key is pressed (correct operation) One beep sounds.

■If an incorrect operation is performed Two or four beeps sound.

■If the machine locks up, for example, because the thread is tangled

The machine beeps for four seconds and the machine automatically stops.

Be sure to check for the cause of the error, and correct it before continuing to embroider.

■Canceling the operation beep

When the machine is purchased, it is set to beep each time an operation panel key is pressed. This setting can be changed so that the machine does not beep.

aTurn on the machine.

3

XThe LCD comes on.

bPresspanel. (Setting key) in the operation

XThe setting screen appears.

cPress (Next page key) twice. dPress OFF for the buzzer.

XThe screen for changing the beep setting appears.

ePress (Back key).

XThe initial screen appears again.

Troubleshooting 85