Bunn TITAN DUAL Enable Energysavr, Procedure to enable energy savings mode Range 0.5 to 24.0 hrs

Page 36

PROGRAMMING THE BREWER (cont.)

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

ENABLE ENERGYSAVR

This function allows the operator to enable the ENERGY SAVINGS mode function and set the idle time. Once the set idle time has expired, the operator can choose to have the heaters either turn off, or reduce the tank holding temp to 140° F (60° C).

Procedure to enable energy savings mode: Range: 0.5 to 24.0 hrs

If enabled, default setting is 140° F (60° C) tank tem- perature after 4.0 hrs. idle time.

1.	Press and hold the right hidden button until the dis-
	play reads SET LANGUAGE. Press the right hidden
	button until the display reads Enabl EnergySavr.
	The YES or NO will be flashing to indicate the cur-
	rent selection.
2.	Press and release the NO button to disable this

10.Once the idle time has expired, the display will read either ENERGY SAVER...NO TEMPERATURE or ENERGY SAVER...REDUCED TEMPERATURE, depending on the settings. This screen will alternate with PRESS ANY SWITCH TO RE-HEAT.

Enabl EnrgySavr

NO DONE YES

WITH YES FLASHING

PRESS DONE

	function, or:
3.	Press and release the YES button to enable this
	function (the heaters will either turn off or the tank
	will hold at 140° F).
4.	When finished, press and release DONE to save
	the new setting and advance to the next function
	screen.
5.	If NO was selected, the display should now read
	EnableFreshTimer. To exit programming and re-
	turn to the MAIN SCREEN, press and release either
	ON/OFF pad.

WITH NO FLASHING

PRESS DONE TO

ADVANCE TO

ENABLEFRESHTIMER

X.X HRS -> IDLE (-) DONE (+)

AFTER IDLE TIME? OFF DONE 140°

6.	If YES was selected, the display should now read
	X.X HRS -> IDLE. This screen allows the operator
	to set the amount of time the brewer is not in use
	before nap mode engages. Using (-)and (+), adjust
	the idle time. When finished, press and release
	DONE.
7.	The display should now read AFTER IDLE TIME?
	Once the set idle time has expired, the heaters can
	either be shut off or held at a lower temperature of
	140° F.
8.	To have the machine shut off after the set idle time,
	press and release OFF and then DONE to save the
	settings. The display should read MACHINE OFF
	AFTER X.X HRS, and then EnableFreshTimer.
9.	To have the heaters hold at the lower 140° F tem-
	perature, press and release 140° and then DONE to
	save the settings. The display should read MACHINE
	AT 140° AFTER X.X HRS, and then EnableFresh-
	Timer.

MACHINE OFF	MACHINE AT 140°
AFTER X.X HRS	AFTER X.X HRS

EnableFreshTimer

NO DONE YES

40119 071107