TROUBLESHOOTING (cont.) |
|
|
| |
PROBLEM |
| PROBABLE CAUSE |
| REMEDY |
Water will not heat or display shows | 1. Limit Thermostat |
| Remove power from the brewer. | |
HEATING TIME TOO LONG. |
|
| Check for continuity through the | |
|
|
|
| limit thermostat. CAUTION: Do not |
|
|
|
| eliminate or bypass limit thermo- |
|
|
|
| stat. Use only replacement part |
|
|
| 23717.0003. | |
|
| 2. Temperature probe |
| Remove the probe from the grom- |
|
|
|
| met and submerge in a water bath |
|
|
|
| of approximately 70°F (21°C). |
|
|
|
| Connect an ohmmeter to the pins |
|
|
|
| in the connector. At 60°F (16°C), |
|
|
|
| the reading should be 15.3k ± 2k |
|
|
|
| OHMS, at 70°F (21°C) the reading |
|
|
|
| should be 11.8k ± 2k OHMS, and |
|
|
|
| at 80°F (27°C) the reading should |
|
|
|
| be 9.3k ± 2k OHMS. If the probe is |
|
|
|
| within these parameters, reconnect |
|
|
|
| to the control board. |
|
| 3. Tank heaters |
| Remove power from the brewer. |
|
|
|
| Check for continuity through the |
|
|
|
| tank heaters. If no continuity is |
|
|
|
| present, check for a wiring problem |
|
|
|
| (consult wiring schematic), then |
|
|
|
| replace the tank heater if no wiring |
|
|
|
| problem is found. |
|
| 4. Control Board |
| Remove power from the brewer. |
|
|
|
| Connect a voltmeter across the |
|
|
|
| tank heater. Reapply power to the |
|
|
|
| brewer and refer to testing outputs |
|
|
|
| on page 40. If the voltage measured |
|
|
|
| when the tank heater is turned on |
|
|
|
| is very low or zero, then substitute |
|
|
|
| a control board know to be good |
|
|
|
| working order. |
Page 52 | 40119 071107 |
|