Bunn TITAN DUAL manual BREW SETTINGS cont SET PULSE BREW/PREINFUSION, Setting Pulse Brew, Next

PROGRAMMING THE BREWER (cont.)

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

BREW SETTINGS (cont.)

SET PULSE BREW/PREINFUSION

This function allows the operator to program the brewer to “pulse” the sprayhead flow on and off during a brew cycle (start and stop the flow of water out of the spray- head). This feature allows the ability to “fine-tune” the brewer for specific flavor profiles. Pulse brewing can be set up for any and all batch sizes.

INITIAL SPRAY	ON-	ON-		ON-
	TIME	TIME		TIME ALTERNATES UNTIL
				BREW CYCLE IS
OFF-	OFF-		OFF-	COMPLETED
TIME	TIME		TIME
INITIAL SPRAY
OFF-TIME	REMAINING ON
PRE-INFUSION				P2293

a)1st ON TIME – This time is the duration from when the brew button is pressed to when the desired water level in the funnel is reached. (Soaking the grounds)

b)OFF-TIME– This time is the duration from when the water in the funnel reached the desired ON TIME to when it drains out of the funnel to a desired lower level.

c)LAST ON-TIME– This time is the duration from when the water in the funnel drains down to the lower level to when it fills the funnel to a desired higher level. (Soaking the grounds)

Setting Pulse Brew

Range: 1ST ON TIME – OFF to 4 minutes OFF TIME – OFF to 4 minutes

LAST ON TIME – Pre-Infusion to 4 minutes

Setting Pulse Brew

1.Press and hold the right hidden button until display reads SET LANGUAGE. Press the right hidden but- ton until display reads BREW SETTINGS ?, along with NO and YES.

2.Press YES to proceed. The display should now read LEFT SIDE, along with MODIFY, SHOW and

NEXT.

3.Press and release the right hidden button until display reads SET PULSE BREW ?, along with NO and YES.

3.Press and release YES. The display should now read 1ST ON TIME X:XX. and a batch light will be blinking.

4.Using (-)and (+), set the total brew time desired including spray times and off times.

5.When finished, press the other batch size and repeat step 4.

6.When finished setting both batch sizes, press DONE. The display will show the pulse settings to accommodate the brew time entered. Press each batch size to display the settings for that batch. If the 1ST ON TIME is set to OFF, the display will read PULSE BREW DISABLED. After a 5 second delay, the display will read 2 BATCHES DONE?.

7.If both batch sizes are not correct, press NO to return to the 1st ON TIME: setup screen and repeat steps 4, 5 and 6.

8.If both batch sizes are correct, press YES. This will advance to DRIP TIME. To exit to the MAIN SCREEN, press and release either ON/OFF button.

Page 23 40119 071107