Bunn TITAN DUAL Batches Done?, PROGRAMMING THE BREWER cont PROGRAMMING FUNCTIONS - LEVEL 2 cont

PROGRAMMING THE BREWER (cont.)

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

BREW SETTINGS (cont.)

Procedure to set or modify BREW METER. Range: 1 to 14 for both batch sizes

NOTE: Using BREW METER will overwrite PULSE BREW settings.

BREW SETTINGS ?

NO YES

PRESSING NO WILL	LEFT SIDE
ADVANCE TO NEXT
FUNCTION SCREEN	MODIFY SHOW NEXT

This function allows the operator to program the brewer to a non-pulsed brew cycle (setting 1), or to “pulse” the sprayhead flow on and off during a brew cycle (start and stop the flow of water out of the sprayhead). Settings 2 thru 14 will produce pulsed brew cycles to increase the brew strenght with 14 being the highest.

SET BOTH

BATCH SIZES

PRESS AND RELEASE

RIGHT HIDDEN SWITCH

UNTIL DISPLAY READS:

L BREW METER X

- I+

1.Press and hold the right hidden button until display reads SET LANGUAGE. Press the right hidden but- ton until display reads BREW SETTINGS ?.

2.Press YES to proceed. The display should now read LEFT SIDE, along with MODIFY, SHOW and

NEXT.

3.Press and release the right hidden button until display reads L BREW METER. A batch light will be blinking.

4. Using (-)and (+), set the brew meter time for that particular batch size.

5.When finished, press the other batch size and repeat step 4.

6.When finished setting both batch sizes, press center program button (Brewer). The display should read

2 BATCHES DONE?

7.If both batch sizes are not correct, press NO to return to the L BREW METER: setup screen and repeat steps 4, 5 and 6.

8.If both batch sizes are correct, press YES. This will advance to SET PULSE BREW. To exit to the MAIN SCREEN, press and release either ON/OFF button.

SET PULSE BREW

NO YES

Page 22 40119 071107