SCP Diagnostics
B.1.2.7 Serial Port Test
This test checks the serial port’s functionality. It takes about two seconds to run.
Serial: OK
B.1.2.8 SRAM Test
This test checks the SRAM’s functionality. It takes about two seconds to run.
NOTE: It is recommended that you back up your CDB before running this test. The SRAM is saved before testing and then restored. However, if a power failure would occur or if the switch were rebooted during the test, some of the data may not be restored properly.
SRAM: OK
B.1.2.9 Timer Test
This test checks to see if the timer is counting correctly. It takes about two sec- onds to run.
Timer: OK
B.1.2.10 Hardware Test
This series of tests checks the functionality of all of the hardware devices in the SCP, except the FLASH chips and SRAM. It takes about fifteen seconds to run.
Clock: OK
DRAM: OK
Ethernet: OK
Timer: OK
}Serial: OK
