Special Recording Modes

Shooting frame rate

109

Playback frame rate

3Press the START/STOP button to begin recording.

•The tally lamp illuminates.

•[S&F] changes to [ÜS&F] while recording.

4Press the START/STOP button again to stop recording.

•A clip is recorded at the set frame rate.

•[S&F STBY`] (during 4K and 2K modes) or [S&F STBY] (during MXF mode) appears at the top of the screen.

•The tally lamp goes out.

Setting the Shooting Frame Rate from the Shooting Screen

If you set an assignable button to [S&F Frame Rate], you can conveniently set the shooting frame rate from the shooting screen without having to go through the menus.

1Set an assignable button to [S&F Frame Rate] (A111).

2 Press the assignable button.

•The shooting frame rate will be highlighted in orange.

3Push the joystick up/down or turn the SELECT dial to select the desired frame rate.

4 Press SET.

•The display of the shooting frame rate will return to normal.

NOTES

•You can use only one special recording mode at a time. In addition, slow & fast motion mode cannot be used with double slot recording.

•While recording, you cannot change the shooting frame rate.

•For lower shooting frame rates, it may take approximately 1 second to stop recording.

•During special recording mode, the time code signal will not be output from the MON. terminals, TIME CODE terminal or HD/SD SDI terminal. During 4K and 2K modes, the time code signal will be output from the 3G-SDI terminals.

•Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the video configuration.

•When the bit rate in the [ 4K/2K/MXF Setup] >[MXF] >[Bit Rate/Resolution] setting is set to [50 Mbps 1920x1080] or [50 Mbps 1280x720], relay recording is not available during slow motion recording.

•During 4K and 2K modes, the running mode of the time code (A84) is set to [Free Run] and cannot be changed. During MXF mode, the running mode is set to [Regen.]. The time code advances while video is recorded. If the running mode of the time code is set to [Free Run] or the time code is input from an external source, the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting.