Using Metadata
Setting a User Memo Using
After completing the necessary preparations (A51) you create a user memo profile and transfer it to the camera from a
98you have two additional advantages over user memos created with Canon XF Utility: you can change the user memo of the last clip recorded, even if you did not specify a user memo in advance; and you can enter manually the GPS information of your shooting location.
1 Press the [Metadata Input] tab on the
2Press
• Alternatively, on the camera, you can set [
4K/2K/MXF Setup] >[Metadata] >[Setting] to [Remote].
3 Fill the necessary user memo and GPS information fields.
• You can press [Clear] to clear the information entered into each field.
4 Press one of the transfer options to transfer the metadata to the camera.
•[Metadata correctly transferred] will be displayed on the
5 Press ^to close the message.
Options
[Apply from Next]: Adds the metadata you set in
[Overwrite Prev.]: | Only available after recording a clip. Adds the metadata you set in |
| after the transfer and also to the last clip recorded (overwriting any user memo that may have been |
| recorded previously with the clip). |
[Overwrite]: | Only available while recording a clip. Adds the metadata you set in |
| being recorded (overwriting any previous user memo). It will also add this metadata to all clips |
| recorded after the transfer. |
NOTES
•The metadata sent to the camera from
-If the camera was turned off.
-If the [
4K/2K/MXF Setup] >[Metadata] >[Setting] setting was changed.
•Metadata sent to the camera from