Using the HD/SD SDI Terminal

Connecting to an External Monitor

[ 4K/2K/MXF Setup]

The digital signal output from the HD/SD SDI terminal includes the video signal, audio signal and time code signal. If necessary, perform the following procedure to change the output to HD or SD*. Turning the output off will conserve the camera’s power.

* Not available for 24.00 Hz recordings.

Operating modes:

1 Open the [Output] submenu.

[HD/SD SDI]

[Output]

[HD]

147

[ 4K/2K/MXF Setup] (in mode) or [¢Video Setup] (in mode) >[HD/SD SDI] >[Output]

2 Select the desired option and then press SET.

•If you selected [SD], you can select the SD resizing method (A148).

•If necessary, adjust the scan mode and resizing method with the [ 4K/2K/MXF Setup] >[HD/SD SDI] > [Scan Mode] and [ 4K/2K/MXF Setup] >[MON. 1 & 2] >[Resize Output] settings. Depending on the video configuration, the scan mode may be set automatically.

•If necessary, you can superimpose the onscreen displays on the video displayed on the external monitor (A149).

Using the HDMI OUT Terminal

The HDMITM OUT terminal also offers a digital connection and outputs both a video and audio signal. The output signal will automatically switch to HD or SD* depending on the capability of the external monitor. You can select the resizing method (A65) when the camera outputs HD video during 4K or 2K mode.

* Not available for 24.00 Hz recordings.

NOTES

•Correct operation cannot be guaranteed when connecting the camera to DVI monitors.

•Video may not be output correctly depending on the monitor. In such case, use another terminal.

•The HDMI OUT terminal is output only. Do not connect the camera to another device’s output terminal using the HDMI OUT terminal as this will cause a malfunction.

•If necessary, you can superimpose the onscreen displays on the video displayed on the external monitor (A149).

•You can select the SD resizing method (A148).

Using the SYNC OUT Terminal

In addition to its function as a synchronization signal output terminal, you can use the SYNC OUT terminal also as a terminal for analog video signal output. You can output an HD component video luminance signal or a down-converted SD composite video signal*.

* Not available for 24.00 Hz recordings.

Operating modes:

1 Open the [Output] submenu.

[ 4K/2K/MXF Setup] (in mode) or [¢Video Setup] (in mode) >[SYNC OUT] >[Output]

2 Select [HD-Y] or [Composite] and then press SET.

mode:

[ 4K/2K/MXF Setup]

mode:

[¢Video Setup]

[SYNC OUT]

[Output]

[Composite]