Recording Video

IMPORTANT

•Observe the following precautions while the CF2or CF3access indicator is illuminated in red. Failure to do so may result in permanent data loss.

56- Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card. - Do not disconnect the power source or turn off the camera.

•Be sure to save your recordings regularly (A152), especially after making important recordings. Canon shall not be liable for any loss or corruption of data.

NOTES

•By default, [ 4K/2K/MXF Setup] >[Rec Command] is set to [On]. With this function, when you connect the camera to another device using the 3G-SDI terminals (in 4K and 2K modes) or HD/SD SDI terminal (in MXF mode), if you start or stop recording with the camera, the other device will also start or stop recording.

•By default, [wOther Functions] >[Fan] is set to [On] and the internal cooling fan will be activated at all times. You can also set the fan to activate when the camera’s internal temperature has risen to a predetermined level.

•When recording MXF clips, the following apply.

-You can use [wOther Functions] >[Rec Review] (A104) to review part or all of the last clip recorded.

-If you set an assignable button to [Add $Mark] or [Add %Mark] (A111), you can press the button to add an $mark or %mark to the last clip recorded.

-You can use [wOther Functions] >[Delete Last Clip] (A175) to delete the last clip recorded. However, you cannot delete the last clip if double slot recording is on.