Canon DS700 Photos from the camera after completing the current, Printing automatically, No Ink

Troubleshooting

Camera Error Message	Try This
Printer in use/Printer	• Photos are being printed from the computer.
warming up	Wait until printing ends. The printer automatically starts printing
	the photos from the camera after completing the current
	printing.
	• Wait until warm-up ends. When it is ready, the printer starts
	printing automatically.
No paper/Paper error	Load the paper, and select Continue*1 in the display on your
	camera.
Paper Jam	Select Stop in the display on your camera to stop printing.
	Remove the jammed paper, load new paper, and press the
	RESUME/CANCEL button on the printer and retry printing.
Printer cover open	Close the cover on the printer.
No print head	The print head is defective or not installed. (The POWER lamp on
	the printer flashes five times.)
	Install a print head. See “Installing the Print Head” on page 5.
	If the print head has already been installed, press the POWER
	button to turn off the printer, and press the POWER button again to
	turn on the printer. If the same error occurs, the print head may be
	defective. Contact a Canon service representative.
Waste tank (ink	The printer has a built-in waste ink absorber to hold the ink used
absorber*2) full	during print head cleaning. This error message indicates that the
	waste ink absorber is nearly full.
	You can continue printing for a while by selecting Continue*1 in
	the display on your camera.
	However, because printing is disabled once the waste ink absorber
	becomes completely full, you are recommended to contact a Canon
	service representative as early as possible.
No Ink	Install an ink tank. Be sure to press the PUSH mark on the ink tank
	to ensure it is firmly seated.
Printer error	An error requiring servicing might have occurred (the POWER lamp
	on the printer flashes alternately orange and green).
	Select Stop in the display on your camera to stop printing.
	Disconnect the cable between the printer and the camera, turn off
	the printer, and unplug the power cord of the printer from the
	power supply. After a while, plug the power cord of the printer back
	in, turn on the printer, and then reconnect the camera to the
	printer.
	If the same error occurs, contact a Canon service representative.

*1: To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue.

*2: The waste ink absorber absorbs ink used at cleaning. Check the printer for proper operation.

74