5.Use f and c to move the highlighting to “Axes” and then use the following operations to configure the settings you want.

 

To select this setting:

 

Press this key:

 

 

 

 

 

Show on-screen axes

 

1(On)

 

 

 

 

 

Hide on-screen axes

 

2(Off)

 

 

 

 

 

Show on-screen axes and scale values

 

3(Scale)

 

 

 

 

6. After the setting is the way you want, press J.

 

kSpecifying Angle and Length Display Units

You can use the procedure in this section to show or hide the units of angle and length values. You also can specify which units should be used for angle and length values.

Angle unit: Deg, Rad

Length: mm, cm, m, km, inch, feet, yard, mile

Angle: Rad, Angle Unit: On

Length Unit: On (mm)

uTo specify angle and length display units

1.Press !m(SET UP) to display the Setup screen.

2.Perform the following operations to configure the settings you want.

To select this setting:

Perform this operation:

 

 

Degrees for display and

Highlight “Angle” and then press 1(Deg).

calculation angle unit

 

 

 

Radians for display and

Highlight “Angle” and then press 2(Rad).

calculation angle unit

 

 

 

Show unit for angle values

Highlight “Angle Unit” and then press 1(On).

 

 

Hide unit for angle values

Highlight “Angle Unit” and then press 2(Off).

 

 

Show unit for length values

1. Highlight “Length Unit” and then press 1(On).

 

2. When the dialog box appears, use keys b

 

through i to specify the length unit.

 

 

Hide unit for length values

Highlight “Length Unit” and then press 2(Off).

 

 

3. After the setting is the way you want, press J.

14-34