ε-25

Using Setup Memory

kUsing and Managing Setups in Setup Memory

All of the setups you save are shown in the setup memory list. After selecting a setup in the list, you can use it to sample data or you can edit it.

• To preview saved setup data

You can use the following procedure to check the contents of a setup before you use it for sampling.

1.On the E-Con2 main menu (page ε-1), press 2(MEMORY) to display the setup memory list.

2.Use the f and c cursor keys to highlight the name of the setup you want.

3.Press K(Setup Preview).

• This displays the preview dialog box.

4. To close the preview dialog box, press J.

• To recall a setup and use it for sampling

Be sure to perform the following steps before starting sampling with the EA-200.

1.Connect the calculator to the EA-200.

2.Turn on EA-200 power.

3.In accordance with the setup you plan to use, connect the proper sensor to the appropriate EA-200 channel.

4.Prepare the item whose data is to be sampled.

5.On the E-Con2 main menu (page ε-1), press 2(MEMORY) to display the setup memory list.

6.Use the f and c cursor keys to highlight the name of the setup you want.

7.Press 1(START).

8.In response to the confirmation message that appears, press 1.

Pressing w sets up the EA-200 and then starts sampling.

To clear the confirmation message without sampling, press 6.

Note

See “Operations during a sampling operation” on page ε-31 for information about operations you can perform while a sampling operation is in progress.

20100801