ε-7

Using the Setup Wizard

9.Use the d and e cursor keys to move the cursor to the end point of the output, and then press w to register it.

After you specify the start point and end point, an output frequency dialog box shown below appears on the display.

10. Input a percent value for the output frequency value you want.

To output the original sound as-is, specify 100%. To raise the original sound by one octave, input a value of 200%. To lower the original sound by one octave, input a value of 50%.

11. After inputting an output frequency value, press w.

This outputs the waveform between the start point and end point from the EA-200 speaker.

If the sound you configured cannot be output for some reason, the message “Range Error” will appear. If this happens, press J to scroll back through the previous setting screens and change the setup as required.

12. To terminate sound output, press the EA-200 [START/STOP] key.

13. Press w.

• This displays a screen like the one shown nearby.

14. Perform one of the following operations, depending on what you want to do.

To change the output frequency and try again:

Press 1(Yes) to return to the “Output Frequency” dialog box. Next, repeat the above steps from step 10.

To change the output range of the waveform graph and try again:

Press 6(No) to return to the graph screen in step 7. Next, repeat the above steps from step 8.

To change the function:

Press 6(No) and then J to return to the graph relation list in step 6. Next, repeat the above steps from step 6.

To exit the procedure and return to the E-Con2 main menu:

Press 6(No) and then press J twice.

20100801