Note

While the AXTRANS screen is displayed, the “Grid” setting on the Setup screen is always “Off”, while the “Label” setting is always “On”. For the “Axes” setting, you can select “On” or “Scale” only. If you try to select “Off” for this setting, it will change back to “On” automatically.

As soon as the AXTRANS screen is displayed, the left screen T-axis V-Window is always configured automatically, regardless of the current “Axtrans Wind” setup.

Pressing K while this screen is shown will display a function menu you can use to perform the following operations.

To do this:

Press this key:

And then perform the procedure
located here:

 

 

 

 

 

Change the display mode

1(Switch)

“To switch the display mode of the

of the left-side screen

 

left side (X-Y coordinate system) of

 

 

the AXTRANS screen” below

 

 

 

Go to the plot list screen

3(List)

 

 

 

Draw a regression graph

4(REG)

From step 3 under “To draw a

overlaid on the plots in

 

regression graph overlaid on plots”

the right-side screen

 

(page 15-10)

 

 

 

Cause plots on the left

5(P-LINK)

“To make plots on the left side and

side and right side of the

 

right side of the AXTRANS screen

AXTRANS screen that

 

that correspond to each other to

correspond to each other

 

flash” (page 15-17)

to flash

 

 

 

 

 

3. To return to the plot list screen, press J.

uTo switch the display mode of the left side (X-Y coordinate system) of theAXTRANS screen

1.While the AXTRANS screen is displayed, press K to display the function menu.

2.Press 1(Switch).

• Each press of 1(Switch) cycles the left-side display mode in the sequence shown below.

(1)Full screen with horizontal squeeze

(2)Cut off screen (no squeeze)

15-16