
Chapter 2 Installation
Installation Procedure | Page 2 - 3 |
Installation
Procedure
Step 1. Move Array to Operation Site
Step 2.
Mount
Enclosure
Install the 6500 disk array as follows:
Move the array to its intended place of operation. Verify that power and communication cables will be accessible, and that the array will be installed in a properly ventilated,
•The standard array enclosure is shipped from the factory ready for placement on a desktop. Attach the supplied rubber feet to the bottom of the enclosure, and position the unit properly on a desk or other work surface.
•If you have ordered the
Step 3.
Attach SCSI
Cable
Step 4. Terminate SCSI Bus, if Necessary
Connect one end of the
If the array is located at the end of the SCSI bus, or if the array is the only peripheral device on the bus, install a termination pack (see the figure below.)
The termination pack will be either
Figure 6 SCSI-P Termination Pack
6500 Disk Array User’s Guide | 21020690 B |