Chapter 4 Maintenance, Troubleshooting & Hardware Replacement
Page 4 - 16 |
| Display/Operation Panel Removal |
Display/
Operation
Panel Removal
1.Perform top cover removal procedure as described previously.
2.Disconnect the display/operation panel’s ribbon cable from the controller board at connector J0401 (see the figure below). Also remove the cable from the clip on the side of the enclosure.
3.Remove screws that hold the panel housing to the front of the array.
4.While lifting the panel away from the array enclosure, guide the ribbon cable connector through its slot to free it from the enclosure.
Replacement Reverse the steps above.
Figure 20 Display/Operation Panel Removal and Replacement
21020690 B | 6500 Disk Array User’s Guide |
