
|
| 6(7'()$8/76 | Chapter 3 | Display/Operation Panel | |||
Page 3 - 14 |
|
| ARRAY OPTIONS | ||||
| SET | Setting theto | <(6 | returns the array to its factory default | |||
DEFAULTS | settings for |
|
| ||||
|
| 0(2))*0(7(5 |
| and | |||
|
| 537 | . The default for this option is 12. |
| |||
RPT AS | $65(&29(5is set to 21when it is necessary for Unit Attention | ||||||
RECOVER | conditions to be reported as Recovered Errors rather than with a Unit Attention. | ||||||
|
| This is determined by the needs of the operating system and the driver. Default | |||||
|
| is | . |
|
|
| |
| TEMP | Use this option to change the temperature at which the array will issue an alarm | |||||
WARNING | and warning display (:, the warning threshold for overheating conditions. This | ||||||
|
| temperature warning can be set in degrees Celsius or Fahrenheit, and refers to | |||||
|
| the temperature detected by the sensor on the controller board. | |||||
| TEMP | In addition to the temperature warning (:), there is another, higher temperature | |||||
CRITICAL | at which the array’s drives are automatically shut down (50 degrees Celsius). | ||||||
|
| This&95is thecritical:5,7($55$(<&3527) | |||||
|
| menu option allows you to enable or disable this automatic shutdown feature. | |||||
|
| Positions are 21and 2)). (When 2)), the unit attention and alarm are still | |||||
|
| issued but the array does not shut down.) |
| ||||
| AUTO | The megometer feature displays the array’s current data transfer rate in | |||||
MEGOMETER | megabytes per second. Because transfer rates vary considerably from moment | ||||||
(ON/OFF) | to moment, the rate shown is actually the average transfer rate for a | ||||||
period. This averaging yields a more accurate representation of overall transfer | |||||||
|
| ||||||
|
| performance. |
|
|
| ||
|
| When the megometer is 21, the transfer rate is the default display unless some | |||||
|
| other message preempts it. When you switch the megometer display 2))the | |||||
|
| transfer rate will not display until you switch it 21again. | |||||
|
|
| Note When you select the auto megometer display, it will not take effect | ||||
|
|
| until the next subsystem reset or power cycle has occurred. | ||||
ARRAY NAME | Use this option to specify a logical name or designator for the array. This feature | ||||||
|
| is a convenience where multiple array units are used and need to be |
distinguished from one another with assigned names. The array name is a user- definable
21020690 B | 6500 Disk Array User’s Guide |