Chapter 4 Maintenance, Troubleshooting & Hardware Replacement
Controller Board Removal | Page 4 - 15 |
Controller Board Removal
1.Perform top cover removal procedure as described previously.
2.Disconnect the array from the SCSI bus. Remove terminator (if used).
3.Remove jack screws for SCSI cables and disconnect all power, drive, and display cables connected to the controller board.
4.Remove the screw at the center of the controller board. Slide the controller board forward slightly to align the mounting bosses with the enlarged portion of the board’s mounting keyholes. Then carefully lift the controller board out of the array enclosure.
Replacement Reverse the steps above.
Figure 19 Controller Board Removal/Replacement
6500 Disk Array User’s Guide | 21020690 B |
