Cisco Systems 12010, 12810, 12410 manual OL-11496-01

Chapter 4 System Startup and Basic System Configuration

Using RP Flash Memory Cards

Step 3 Insert the card into the appropriate slot until the card completely seats in the connector and the ejector button pops out (see Figure 4-5b).

Caution The flash memory card is keyed for proper insertion. The ejector button does not pop out unless the card is inserted correctly. Part of the card remains outside of the slot even when the card is properly seated. Do not attempt to force the card deeper into the slot after the ejector button pops out.

Step 4 Replace the flash memory card slot cover.

Use the following procedure to remove a flash memory card.

Step 1 Remove the flash memory slot cover by loosening its captive screw (illustration is shown without the cover for clarity).

Step 2 Press the appropriate ejector button to eject the card from the connector at the back of the slot (see Figure 4-5c).

Step 3 Pull the card from the slot and place it in an antistatic bag to protect it from ESD damage.

Step 4 Replace the flash memory card slot cover.

	Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01		4-45