Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Milo# copy startup-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCC
Milo#
•The exclamation points (!!!) appear as the file is being copied.
•The C characters signify the calculation of the CRC, which verifies that the file is copied correctly.
Step 3 Enter the dir command to verify that the configuration file is copied correctly to the memory card in slot 0.
Milo# dir slot0: |
|
| ||
name | ||||
1 | 5200084 | May | 10 1997 19:24:12 | |
31215 May 10 1997 20:30:52 myfile1
46176844 May 10 1997 23:04:10
51186 May 10 1997 16:56:50 myfile2
9197156 bytes available (11381148 bytes used) Milo#
|
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |
|
|
|
|
| ||
|
|
|
| |
|
|
|
