Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Copying the Startup Configuration File from NVRAM to a Flash Memory Card
Use the following procedure to copy a configuration file from NVRAM to a flash memory card.
Step 1 Enter the show bootvar command to display the current setting for the environmental CONFIG_FILE variable.
Note The environmental CONFIG_FILE variable must point to NVRAM (system default).
Milo# show bootvar
.
.
.
CONFIG_FILE variable =
Current CONFIG_FILE variable =
.
.
.
Milo#
The absence of any notation following the CONFIG_FILE variable statement as shown in this example indicates that the environmental variable is pointing to
NVRAM.
Step 2 Enter the copy command in the following form:
copy startup-config [slot0: slot1:] filename
Where:
•
•[slot0: slot1:] specifies the destination of the configuration file to be copied.
•filename is the name of the configuration file.
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |
|
