Cisco Systems 12010, 12810, 12410 manual Enter the initialize command to initialize the router

Chapter 4 System Startup and Basic System Configuration

Recovering a Lost Password

enable “use net in IP bcast address”? y/n [n]: enable “load rom after netbootfails”? y/n [n]: enable “use all zero broadcast”? y/n [n]: enable “break/abort has effect?” y/n [n]: enable “ignore system config info?” [n]: y change console baud rate? y/n [n]:

change boot characteristics? y/n [n]

Configuration Summary enabled are: console baud: 9600

boot: image specified by the boot system command

or default to: cisco2-prp

do you wish to change the configuration? y/n [n]

You must reset or power cycle for the new config to take effect rommon 1>

Step 4 Enter the initialize command to initialize the router.

rommon 1> initialize

After the router completes its power cycle, the software configuration register is set to ignore the configuration file. The router boots the system image and displays the system configuration dialog:

--- System Configuration Dialog ---

.

.

.

Step 5 Enter no in response to the system configuration dialog prompts until the following instruction is displayed:

Press RETURN to get started!

Step 6 Press Return.

After some interface configuration information is displayed, the user EXEC mode prompt appears:

Milo>

	Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
4-42	OL-11496-01