AT&T Remote Port Security Device Rpsd System Administrator Command Set, Add User, Syntax

RPSD System Administrator Command Set

This section describes the commands available on the RPSD Lock and their syntax. The procedures in which the commands are used have been described earlier in this chapter. This material is provided as a quick reference.

Also described in this section is the method of accessing the help screens that accompany the Menu of Commands.

The Menu of Commands available to the system administrator is as follows:

- Menu of Commands ---
A	-	Add	User		LH - Log History			D	- Date Set
B	-	Block User			AH - Access		History	C	- Clock Set
U	-	Unblock		User	FH - Failure		History	I	- ID Set
T	-	Test	User					SC	- Set Comms. Params
R	-	Remove		User	ST - Status Display
L	-	List	User Table		LS - List	Statistics
					RS - Reset	Statistics
CR - Change				Restriction
LR - List			Restrictions		FC - Force	Connect
UR - User			Restrictions		FD - Force	Disconnect

-- For Help Type ‘?’ Followed By Command --

>

Note: The Menu of Commands is available at any time by pressing [ RETURN ] on the RPSD administration terminal. The commands are not case sensitive.

A - Add User

Syntax:

a <user_id>,[secret_key] [ RETURN ]

Adds an RPSD Key user to the list of users on the RPSD Lock. The total number of RPSD Key users at any one time is limited to twenty-five. Of the twenty-five users, ten are permanent users and cannot be removed.

The [secret_key] can be specified by the system administrator or randomly assigned by the Lock. If this field is omitted, it is randomly generated by the Lock.

RPSD System Administrator Command Set 3-7