S - Status Display
Syntax:
s[ RETURN ]
The Status Display command displays the current status of the RPSD Key to the user’s terminal.
To use this command, enter s [ RETURN ] at the > prompt.
Sample Command and Response:
>s |
|
|
|
|
|
|
AT&T | RPSD/KEY11 - | V1.0 | Firmware | V2.0x | Init Code: | |
Current | Date: Mon | 08/14/90 | Time: | 14:28:09 | Log ID: 12345678 | |
Comms | Set to: 9600/8N |
|
|
| ||
Current | Status: Idle |
|
|
| ||
|
|
|
|
|
|
|
The fields of the Status Display screen are:
AT&T | Gives the version number of the equipment and the Key user ID. |
RPSD/KEY11 |
|
Firmware | Gives the version number of the firmware. |
Init Code | Tells where and when the device was initialized. |
Current Date | Gives the current date. If the date is wrong, it can be corrected using the |
| Date Set command described in this section. |
Time | Gives the current time. If the time is wrong, it can be corrected using the |
| Time Set command described in this section. |
Log ID | Provides the Log ID of the RPSD Key. To set a Log ID, use the Set Log ID |
| command described in this section. |
Comms Set to | Displays the setting of the communications parameters. To change the |
| communications parameters, use the Set Communications Parameters |
| command described in this section. The default setting is 9600 baud at |
| 8 bits, no parity. |
Current Status | Provides the current status of the Key. |
RPSD Key User Command Set |
