ST - Status Display
Syntax:
st [ RETURN ]
The Status Display command displays the version, date, time, communications parameters, and current status of the RPSD Lock.
Sample Command and Response:
> st |
|
|
|
|
AT&T | RPSD/JPLock01 - V1.1a Firmware V2.Ot | Init. Code: DR | ||
Current | Date: Mon 11/12/90 Time: 16:11:55 | Log ID: | ||
Comms. | Set to: | 9600/8N |
| |
Current | Status: | Idle/Locked |
| |
|
|
|
|
|
The fields of the Status Display screen are:
AT&T | Gives the version number of the equipment. |
RPSD/JPLock01 |
|
Firmware | Gives the version number of the firmware. |
Init Code | Tells where and when the device was initialized. |
Current Date | Gives the current date. If the date is wrong, it can be corrected using the |
| Date Set command described in this section. |
T i m e | Gives the current time. If the time is wrong, it can be corrected using the |
| Time Set command described in this section. |
Log ID | Provides the Log ID of the RPSD Lock. To set a Log ID, use the |
| Set Log ID command described in this section. |
Comms Set to | Displays the setting of the communications parameters. To change the |
| communications parameters, use the Set Communications Parameters |
| command described in this section. The default setting is 9600 baud at |
| 8 bits, no parity. |
Current Status | Provides the current status of the Lock. |
