AT&T Remote Port Security Device user manual Access Failure Messages Code Meaning Action

TABLE 5-1 (Continued)

Access Failure Messages

Code	Message	Meaning	Action
No.
4	Blocked User	The	No action necessary. This is a deliberate
		administrator	Block command issued by the administrator.
		placed a block
		on the caller’s
		RSPD Key user
		ID.
5	Invalid	The RSPD Key	Check the Test Responses to make sure the
	Response	responded to	RSPD Lock and RSPD Key Test Responses
		the RSPD	match (see Chapters 3 and 4 for checking
		Lock’s	Test Responses). If access for this Key is
		challenge, but	desired, and the Test Responses do not
		the response	match, you will need to use the Wipe Out
		was incorrect.	command (see Chapter 4, RSPD Key Use) to
			return the Key to a virgin state. Then follow
			the directions for initializing the RSPD Key,
			also found in Chapter 4.
6	Outgoing Call	An outgoing	No action necessary.
		call is being	This is not a call failure.
		placed. If a call
		is connected,
		the Lock forces
		a disconnect in
		order to make
		the outgoing
		call.
7	Ring - No	The RSPD	Run the Modem Ring Test described in this
	Answer	Lock rang the	chapter and follow the directions for
		modem, but the	determining the cause of failure.
		modem did not
		pick up.
8	Force	A Force	No action necessary. This is a
	Disconnect	Disconnect	deliberate disconnect command
		command was	issued by the administrator.
		issued to the
		RSPD Lock.

Access Failure Messages 5-5