Cisco Systems 15454-FTF2 4.20 OC192SR1/STM64IO Short Reach and OC192/STM64 Any Reach Cards

4-50
Cisco ONS 15454 Reference Manual, R8.5.x
78-18106-01
Chapter 4 Optical Cards
4.20 OC192SR1/STM64IO Short Reach and OC192/STM64 Any Reach Cards
4.20 OC192SR1/STM64IO Short Reach and OC192/STM64 Any
Reach Cards
Note For hardware specifications, see the “A.6.19 OC192SR1/STM64IO Short Reach Card Specifications”
section on page A-47 and the “A.6.20 OC192/STM64 Any Reach Card Specifications” section on
page A-47. See Table 4-2 on page 4-5 for optical card compatibility.
The OC192SR1/STM64IO Short Reach and OC192/STM64 Any Reach cards each provide a single
OC-192/STM-64 interface, as follows:
• OC192SR1/STM64IO Short Reach card (SR-1)
• OC192/STM-64 Any Reach card (SR-1, IR-2, and LR-2)
In CTC, these cards are referred to as “OC192-XFP” cards.
The interface operates at 9.952 Gbps over single-mode fiber spans and can be provisioned for both
concatenated and nonconcatenated payloads on a per STS-1/VC-4 basi s. Specification references can be
found for the OC-192/STM-64 interface in ITU-T G.691, ITU-T G.693, and ITU-T G.959.1, and
Telcordia GR-253.
The optical interface uses a 10-Gbps Form-factor Pluggable (XFP) optical transceiver that plugs into a
receptacle on the front of the card. The OC192SR1/STM64IO Short Reach card is used only with an
SR-1 XFP, while the OC192/STM-64 Any Reach card can be provisioned for use with an SR-1, IR-2,
LR-2, or DWDM XFP module. The XFP SR, IR, and LR interfaces each provide one bidirectional
OC192/STM64 interface compliant with the recommendations defined by ITU-T G.91. SR-1 is
compliant with ITU-T I-64.1, IR-2 is compliant with I TU G.691 S-64.2b, and LR-2 is compliant with
ITU G.959.1 P1L1-2D2.
The cards are used only in Slots 5, 6, 12, and 13. and only with 10-Gbps cross-connect cards, such as
the XC10G and XC-VXC-10G.
Note The OC192SR1/STM64IO Short Reach and OC192/STM64 Any Reach cards support an errorless
software-initiated cross-connect card switch when used in a shelf equipped with XC-VXC-10G and
TCC2/TCC2P cards.
Figure 4-23 shows the faceplates and block diagram for the two cards.