9-5
Cisco ONS 15454 Reference Manual, R8.5.x
78-18106-01
Chapter 9 Security
9.2.1 User Privileges by CTC Action
Table 9-2 shows the actions that each user privilege level can perform in network view.
Audit Retrieve ———X
Archive — — X X
Test Access View X X X X
DWDM APC: Run/Disable/Refresh — X X X
WDM Span Check:
Edit/Retrieve Span Loss
values/Reset
XXXX
ROADM Power Monitoring:
Refresh
XXXX
PP-MESH Internal Patchcord:
Refresh
XXXX
Install Without Metro Planner:
Retrieve Installation values
XXXX
All Facilities: Mark/Refresh X X X X
1. X indicates that the user can perform the actions.
2. — indicates that the privilege to perform an action is not available to the user.
3. Provisioner user cannot change node name, contact, location, or AIS-V insertion on STS-1 signal degrade (SD) parameters.
4. The action buttons in the subtab are active for all users, but the actions can be completely performed only by the users with the required security levels.
Table 9-1 ONS 15454 Security Levels—Node View (continued)
CTC Tab Subtab [Subtab]:Actions Retrieve Maintenance Provisioning Superuser
Table 9-2 ONS 15454 Security Levels—Network View
CTC Tab Subtab [Subtab]: Actions Retrieve Maintenance Provisioning Superuser
Alarms — Synchronize/Filter/Delete
cleared alarms
X1XXX
Conditions — Retrieve/Filter X X X X
History — Filter X X X X
Circuits Circuits Create/Edit/Delete —2—X X
Filter/Search X X X X
Rolls Complete, Force Valid Signal,
Finish
—— X X