15-47
Cisco ONS 15454 Reference Manual, R8.5.x
78-18106-01
Chapter 15 Performance Monitoring
15.6.4 CE-Series Ethernet Card Performance Monitoring Parameters
Note Line utilization numbers express the average of ingress and egress traffic as a percentage of capacity.
15.6.4.3 CE-Series Card Ether Ports History Window
The Ethernet Ether Ports History window lists past Ethernet statis tics for the previous time intervals.
Depending on the selected time interval, the History window displays the statistics for each port for the
number of previous time intervals as shown in Table 15-15 on page 15-31. The listed parameters are
defined in Table 15-21 on page 15-44.
15.6.4.4 CE-Series Card POS Ports Statistics Parameters
The Ethernet POS Ports statistics window lists Ethernet POS parameters at the line level. Table 15-22
defines the CE-Series Ethernet card POS Ports parameters.
Table 15-22 CE-Series Card POS Ports Parameters
Parameter Definition
Time Last Cleared A time stamp indicating the last time that statistics were reset.
Link Status Indicates whether the Ethernet link is receiving a valid Etherne t signal
(carrier) from the attached Ethernet device; up means present, and down
means not present.
ifInOctets Number of bytes received since the last counter reset.
rxTotalPkts Number of received packets.
ifInDiscards1The number of inbound packets that were chosen to be discarded even
though no errors had been detected to prevent their being deliverable to a
higher-layer protocol. One possible reason for discarding such a packet
could be to free buffer space.
ifInErrors1The number of inbound packets (or transmission units) that contained err ors
preventing them from being deliverable to a higher-layer protocol.
ifOutOctets Number of bytes transmitted since the last counter reset.
txTotalPkts Number of transmitted packets.
ifOutOversizePkts1Packets greater than 1518 bytes transmitted out a port.
gfpStatsRxFrame2Number of received GFP frames.
gfpStatsTxFrame2Number of transmitted GFP frames.
gfpStatsRxCRCErrors Number of packets received with a payload FCS error.
gfpStatsRxOctets2Number of GFP bytes received.
gfpStatsTxOctets2Number of GFP bytes transmitted.
gfpStatsRxSBitErrors Sum of all the single bit errors. In the GFP CORE HDR at the GFP-T
receiver, these are correctable.
gfpStatsRxMBitErrors Sum of all the multiple bit errors. In the GFP CORE HDR at the GFP-T
receiver, these are uncorrectable.
gfpStatsRxTypeInvalid Number of receive packets dropped due to Client Data Frame UPI errors.
gfpStatsRxCIDInvalid1Number of packets with invalid CID.