8-10
Cisco ONS 15454 Reference Manual, R8.5.x
78-18106-01
Chapter 8 Cisco Transport Controller Operation
8.6.1 Node View
The wording on a card in node view shows the status of a card (Active, Standby, Loading, or
Not Provisioned). Table 8-5 lists the card statuses.
The port color in both card and node view indicates the port se rvice state. Table 8-6 lists the port colors
and their service states. For more information about port service states, see Appendix B, “Administrative
and Service States.”
Table 8-5 Node View Card Statuses
Card Status Description
Sby Card is in standby mode.
Act Card is active.
NP Card is not present.
Ldg Card is resetting.
Mis Card is mismatched.
Table 8-6 Node View Card Port Colors and Service States
Port Color Service State Description
Blue OOS-MA,LPBK (Out-of-Service and Management, Loopback) Port is in a
loopback state. On the card in node view, a line between
ports indicates that the port is in terminal or facility
loopback (see Figure 8-4 on page 8-11 and Figure 8-5 on
page 8-11). Traffic is carried and alarm reporting is
suppressed. Raised fault conditions, whether or not their
alarms are reported, can be retrieved on the CTC
Conditions tab or by using the TL1 RTRV-COND
command.
Blue OOS-MA,MT (Out-of-Service and Management, Maintenance) Port is
out-of-service for maintenance. Traffic is carried and
loopbacks are allowed. Alarm reporting is suppressed.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. Use OOS-MA,MT
for testing or to suppress alarms temporarily. Change the
state to IS-NR, OOS-MA,DSBLD, or OOS-AU,AINS
when testing is complete.
Gray OOS-MA,DSBLD (Out-of-Service and Management, Disabled) The port is
out-of-service and unable to carry traffic. Loopbacks are
not allowed in this service state.