Chapter 4 Basic and Additional SIP Services

Additional SIP Services

Receiver-tagged VIA header

You can disable or enable the processing the received = parameter in the Via header. This feature is disabled by default.

Related Parameter

ConnectMode, page 5-28—Bit 22

Repeat Dialing on Busy Signal

This feature allows the Cisco ATA to repeatedly call a busy number at a periodic interval for a specific length of time. Both the interval and total time can be specified by the user.

To use this feature, configure FeatureTimer bits 0-7 and add the new command/action values "#37#;kA" to the existing “H” context and “5;jA” to the existing “S” context in the CallCmd parameter.

This feature is invoked by pressing 5 after the busy tone sounds. The caller then gets a beep confirmation followed by silence. When the subscriber hangs up, the Cisco ATA starts to redial at the interval specified in FeatureTimer bits 4-7. When the called party rings, the caller is notified with a special ring. If the called party picks up the call first, the called party receives a ringback. If the caller picks up the call first, the caller receives the ringback. This feature is automatically cancelled when the called party rings.

Note For this feature to work properly, the remote user agent server must return a 486 (Busy Here) response to an INVITE request if it detects that the remote party (IP or PSTN) is busy. If the server returns a 183 (Session Progress) response with an SDP before a 486, the Cisco ATA considers the call successful and automatically cancels repeat dialing.

Related Parameters

FeatureTimer, page 5-26—Bits 0 to 3 control the maximum time the Cisco ATA redials a number.

FeatureTimer, page 5-26—Bits 4 to 7 control the interval between each redial that the Cisco ATA performs.A value of zero (0) sets the default redial interval to 15 seconds.

CallCmd, page 5-47—The following context commands are used as follows:

Parameter:

CallCmd

Context:

S (may also include 'a' or 'b')

Command/action:

5;jA

Description:

This context command adds the service activation code to enable

repeat dialing.

 

Parameter:

CallCmd

Context:

H

Command/action:

#37#;kA

Description:

This context command adds the service deactivation code to disable

repeat dialing

 

Note For complete information about call commands, see Chapter 6, “Call Commands.”

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

 

OL-3410-01

4-9

 

 

 

Page 65
Image 65
Cisco Systems 186, 188 manual Receiver-tagged VIA header, Repeat Dialing on Busy Signal