![](/images/new-backgrounds/1310414/31041471x1.webp)
Chapter 3 Configuring the Cisco ATA for SIP
Default Boot Load Behavior
•Cisco ATA Web Configuration Page, page
•Refreshing or Resetting the Cisco ATA, page
•Upgrading the SIP Signaling Image, page
Note The term Cisco ATA is used throughout this manual to refer to both the Cisco ATA 186 and the Cisco ATA 188, unless differences between the Cisco ATA 186 and Cisco ATA 188 are explicitly stated.
Default Boot Load Behavior
Before configuring the Cisco ATA, you need to know how the default Cisco ATA boot load process works. Once you understand this process, you will be able to configure the Cisco ATA by following the instructions provided in this section and in the sections that follow.
All Cisco ATAs are shipped with a bootload
In addition, the Cisco ATA obtains its configuration file during the bootload process.
The following list summarizes the default Cisco ATA behavior during its
1.The Cisco ATA uses the Cisco Discovery Protocol (CDP) to discover which VLAN to enter. If the Cisco ATA receives a VLAN ID response from the network switch, the Cisco ATA enters that VLAN and adds 802.1Q VLAN tags to its IP packets. If the Cisco ATA does not receive a response with a VLAN ID from the network switch, then the Cisco ATA assumes it is not operating in a VLAN environment and does not perform VLAN tagging on its packets.
Note If your network environment is not set up to handle this default behavior, make the necessary configuration changes by referring to the “Specifying a Preconfigured VLAN ID or Disabling VLAN IP Encapsulation” section on page
2.The Cisco ATA contacts the DHCP server to request its own IP address.
Note If your network environment does not contain a DHCP server, you need to statically configure various IP addresses so that the Cisco ATA can obtain network connectivity. For a list of parameters that you must configure to obtain network connectivity, see Table
3.Also from the DHCP server, the Cisco ATA requests the IP address of the TFTP server.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
| ||
|