Cisco Systems 186, 188 manual What You Need, Installation Procedure, 5V power adaptor Power cord

Chapter 2 Installing the Cisco ATA

What You Need

•Regulatory Compliance and Safety Information for the Cisco ATA 186 and Cisco ATA 188

•5V power adaptor

•Power cord

Note The Cisco ATA is intended for use only with the 5V DC power adaptor that comes with the unit.

What You Need

You also need the following items:

•Category-3 10BASE-T or 100BASE-T or better Ethernet cable. One cable is needed for each Ethernet connection.

A Category-3 Ethernet cable supports 10BASE-T for up to 100 meters without quality degradation, and a Category-3 Ethernet cable supports 100BASE-T for up to 10 meters without quality degradation.

For uplink connections, use a crossover Ethernet cable to connect the Cisco ATA to another Ethernet device (such as a router or PC) without using a hub. Otherwise, use straight-through Ethernet cables for both uplink and data port connections.

•Access to an IP network

•One or two analog Touch-Tone telephones or fax machines, or one of each

Installation Procedure

After the equipment is in place, see Figure 2-1(for Cisco ATA 186) or Figure 2-2(for Cisco ATA 188) and follow the next procedure to install the Cisco ATA.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

OL-3410-01 2-3