Cisco Systems 186, 188 manual CallFeatures, Clipclir

Chapter 5 Parameters and Defaults

Operating Parameters

CallFeatures

Description

Disable/enable CallFeatures by setting each corresponding bit to 0 or 1.

The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port. Table 5-2provides definitions of each bit.

Note The subscribed features that can be permanently disabled by the user are CLIP_CLIR, call waiting and Fax mode. A subscribed service enable/disabled by the user can be disabled/enabled dynamically on a per-call basis.

Value Type

Bitmap

Default 0xffffffff

	Voice Configuration Menu Access Code
	314
Table 5-2 CallFeatures Parameter Bit Definitons
Bit
Number	Definition
0	Forward unconditionally
1	Forward on busy
2	Forward on no answer
3	CLIP_CLIR
4	Call waiting
5	three-way calling
6	Blind transfer
7	Transfer with consultation. This service allows the user to transfer the remote party to a different number by first
	calling that number and consulting with the callee.
8	Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
	device attached to the FXS line.
9	Call return
10	Message waiting indication
11	Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK).

15Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use the following settings:

•G711 codec only

•No silence suppression

•No FAX tone detection

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

OL-3410-01 5-23