Cisco Systems 188, 186 manual ConnectMode, Rtp

Chapter 5 Parameters and Defaults

Operating Parameters

ConnectMode

Description

This parameter is a 32-bit bitmap used to control the connection mode of the selected call signaling protocol. Table 5-4 on page 5-28provides bit definitions for this parameter.

Value Type

Bitmap

Default 0x00060400

	Voice Configuration Menu Access Code
	311
Table 5-4 ConnectMode Parameter Bit Definitions
Bit Number	Definition
0—H.323 only	0—Enable normal start.
	1—Enable fast start.
1—H.323 only	0/1—Disable/enable h245 tunneling.
2	0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
	µ-law/G.711 A-law.
	1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
	µ-law/G.711 A-law.
3—H.323 only	0/1—Disable/enable the requirement for the alternate gatekeeper to register.
4—H.323 only	0—Denotes a non-Cisco CallManager environment.
	1—Enable the Cisco ATA to operate in a Cisco CallManager environment.
5—H.323 only	0/1—Enable/disable two-way cut-through of voice path before receiving CONNECT message.
6—H.323 only	0/1—Disable/enable using the Progress Indicator to determine if ringback is supplied by the far end with
	RTP.
7	0/1—Disable/enable fax pass-through redundancy.
8-12	Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number
	of 96. The valid range is 0-23; the default is 4.
	For example, if the offset is 4, the NSE payload type is 100.
13	0—Use G.711µ-law for fax pass-through codec.
	1—Use G.711A-law for fax pass-through codec.
14-15	0—Use fax pass-through.
	1—Use codec negotiation in sending fax.
	2—Reserved.
	3—Reserved.
16—SIP only	0/1—Disable/enable SIP to remove the registration before adding a new one.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

5-28 OL-3410-01