Chapter5 Troubleshooting the System Hard ware
Symptoms and Solutions
5-48
Cisco Wide Area Application Engine 7326 Hardware Installation Guide
OL-6831-02
Table5-17 Power Problems
Symptom FRU or Action
The device does not power up. 1. Verify the following items:
a. The power AC LEDs are on.
b. The power cables are properly connected to the device.
c. The electrical outlet functions properly.
d. The type of memory installed is correct.
e. If you just installed a hardware option, remove it, and restart
the device. If the device now powers up, you might have
installed more hardware options than the power supply
supports.
2. If LEDs for CPUs or VRMs are on, verify these items:
a. A VRM is populated for each microprocessor.
b. All microprocessors have identical cache sizes, dock speeds,
and clock frequencies.
c. Override the front panel push button by turning on switch 7
of SW1; if power comes on, then there is a service processor
error and the power reset card needs to be replaced.
3. See the “Undetermined Problems” section on page5-25.
The device does not power
down.
1. Determine whether you are using an ACPI 1or non-ACPI
operating system. If you are using a non-ACPI operating system:
a. Press Ctrl+Alt+Delete.
b. Power down the system by holding the power control button
for 4 seconds.
c. If the device fails during BIOS POST and the power control
button does not work, remove the AC power cord.
2. If the problem remains or if you are using an ACPI-aware
operating system, suspect the system board.
1. APCI = Advanced Configuration and Power Interface.