3-5
Cisco Wide Area Application Engine 7326 Hardware Installation Guide
OL-6831-02
Chapter3 Installing the Wi de Area Application Engine
Installing the Wide Area Application Engine 7326
Installing the Wide Area Application Engine 7326
Place the WAE in the desired location. You can mount it in a rack for your
convenience, or place it on a solid, stable surface. If you do not plan to install the
appliance in an equipment rack, proceed to the “Installing the Chassis on a
Tabletop” section on page3-11.
To install the WAE in a rack, follow these steps:
Step1 Push outward on the slide-rail latch (labeled 2 in Figure3-2). Pull the latch back
to open the slide rail. The latch will engage and stay open. Open the other end of
the slide rail. Repeat the entire process for the other slide rail.
Note If you are installing the server in the top of the rack or directly under another
server or device, remove the cable-management arm bracket from the
cable-management assembly and install the cable-management arm bracket on the
slide rail. Go to step 6 to install the cable-management arm bracket; then, continue
with step 2.
Figure3-2 Latching the Slide Rails
134570
2
1