Chapter5 Troubleshooting the System Hard ware
Identifying System Problems
5-4
Cisco Wide Area Application Engine 7326 Hardware Installation Guide
OL-6831-02
To check all the connections and switches, follow these steps:
Step1 Power down the system, including any attached peripherals such as external
drives. Disconnect all the power cables from their electrical outlets.
Step2 If the system is connected to a power strip (or power distribution unit), turn the
power strip off and then on again.
Is the power strip receiving power?
Yes. Go to Step 5.
No. Go to Step 3.
Step3 Plug the power strip into another electrical outlet.
Is the power strip receiving power?
Yes. The original electrical outlet probably does not function. Use a different
electrical outlet.
No. Go to Step 4.
Step4 Plug a system that you know works into the electrical outlet.
Does the system receive power?
Yes. The power strip is probably not functioning properly. Use another power
strip.
No. Go to Step 5.
Step5 Reconnect the system to the electrical outlet or power strip.
Make sure that all connections fit tightly together.
Step6 Power up the system.
Is the problem resolved?
Yes. The connections were loose. You have fixed the problem.
No. Call your service representative. (See the “Obtaining Technical Assistance”
section on pagexx.)