Cisco Systems 78-16356-01 manual Installing Your GSS, Installing the GSS in a Four-Post Rack

Chapter 3 Installing the GSS

Installing Your GSS

Concurrently, report the nature and extent of the damage to Customer Service. Report the problem or deficiency to Customer Service along with the model number and serial number. Upon receipt of this information, you will be provided with service instructions, or a Return Material Authorization (RMA) number and shipping information. To obtain assistance, refer to the “Preface”.

Installing Your GSS

Place the GSS in the desired location. You can mount it in a rack for your convenience, or place it on a solid, stable surface. If you do not plan to install the GSS in an equipment rack, proceed to the “Installing the GSS on a Workbench or Tabletop” section.

Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the GSS remains stable. The following guidelines are provided to ensure your safety:

This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006

This section contains the following procedures:

•Installing the GSS in a Four-Post Rack

•Attaching a Two-Post Rack Bracket to the GSS

•Installing the GSS on a Workbench or Tabletop

	Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01		3-3