Cisco Systems ASA5525IPSK9, ASA5515K9, kygjygcjgf manual Removing and Installing the Power Supply

Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X

Removing and Installing the Power Supply

Step 3 Grasp the SFP on both sides, and remove it from the port.

Removing and Installing the Power Supply

•Removing and Installing the AC Power Supply, page 4-13

•Installing the DC Input Power, page 4-15

•Removing and Installing the DC Power Supply, page 4-19

Removing and Installing the AC Power Supply

Caution If you remove a power supply, replace it immediately to prevent disruption of service.

Caution If the appliance is subjected to environmental overheating, it shuts down and you must manually power cycle it to turn it on again.

Warning This unit has more than one power supply connection; all connections must be removed completely to completely remove power from the unit. Statement 102

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than: 120 VAC, 20A U.S. (240 VAC, 10A international). Statement 1005

Note This procedure applies only to the appliances with a removable AC power supply (ASA 5545-X and ASA 5555-X). If only one power supply is installed, make sure that it is installed in slot 0 (left slot) and that slot 1 (right slot) is covered with a slot cover.

To remove and install the AC power supply, follow these steps:

Step 1 If you are adding an additional power supply, from the back of the appliance, push the lever on the slot cover to the left to release it, grasp the handle of the slot cover and pull it away from the chassis. (See Figure 4-16.) Save the slot cover for future use. Continue with Step 3.

Cisco ASA 5500-X Series Hardware Installation Guide

4-13