C-9
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
Appendix C Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
Step 10 These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, select option 2 to
save it in NVRAM.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. To
change this configuration or to perform other management tasks, enter commands at the Switch> prompt.